TideLog Posts Tagged “R52”

I recently had a TideLog reader, Steve, contact me about his Menvier TS800 control panel, saying the panel was fine, but the charge voltage was intermittent, even with a new battery. A few days afterwards he dropped it off to me, lo and behold, just like the Optima, a worn resistor, under the keypad. Here’s a picture of what it should look like, and where it is located:

Menvier-TS800-resistors-locationThe one I’ve highlighted in green, labelled R52, supplies the +ve 13.6v feed to the battery, via D14 to the bottom left of it, which also seems to supply the telephone module terminal block with +ve voltage too. R83, which is the green resistor highlighted in blue, supplies the AUX 12v for PIR’s and such, and 12.6v to the bell.

Check both resistors, and all diodes for continuity and correct resistance, use my band code chart, in the Optima article, by clicking HERE. R52 on Steve’s board wasn’t badly burnt, but the resistor ceramic coating, along with the colour bands, had come off, there was slight burn evidence at the solder joints, and the voltage was stable until the board was under load, once the resistor warms up it breaks down when loaded with a flat battery on the charge rail.

Comments No Comments »